LED Saddlebag Run / Brake / Turn Signals Install from HOGWORKZ® ('14+ Harley® Touring Models)

HOGWORKZ® LED saddlebag lights are extremely bright, as well as plug and play for any '14-later Harley Davidson touring models equipped with hard saddlebags. These saddlebag LED lights will work with standard or stretched bags, both HOGWORKZ® as well as OEM. Install is a breeze, and as with all HOGWORKZ® LED products, are backed by a lifetime warranty!

1. Prepare the Motorcycle:

  • Remove the OEM seat to access the main lighting wire harness.
  • Remove the OEM saddlebag and OEM side cover.
360_20250331134824_

2. Connect the Wiring Harness:

  • Disconnect the OEM wiring harness.
  • Connect the new Hogworks wiring harness to the rear wire harness on your motorcycle.
360_20250331135435_

3. Connect the LED Saddlebag Light:

  • Plug in the LED saddlebag light to the new wiring harness.
  • Double-check that you are connecting the light to the correct side of the motorcycle.

4. Route the Wiring:

  • Run the wiring harness along the motorcycle frame, creating a clean line.
  • Use zip ties to secure the wiring in place.
  • Ensure you leave enough slack in the wiring to allow for proper mounting of the saddlebag light to the back of the saddlebag.
360_20250331135704_

5. Secure Excess Wiring:

  • Zip tie any excess slack in the wiring before attaching the saddlebag light.
360_20250331140036_

6. Reinstall Side Cover:

  • Reinstall the OEM side cover before reinstalling the saddlebag.
360_20250331140308_

7. Reinstall Saddlebag and Attach LED Light:

  • Reinstall the OEM saddlebag.
  • Clean the surface of the saddlebag where the LED light will be attached, removing any dirt or debris.
  • Remove the backing from the 3M adhesive tape on the back of the saddlebag light.
  • Press the LED light firmly onto the saddlebag, ensuring it is properly adhered.

8. Repeat for Other Side:

  • Repeat steps 2 through 7 on the opposite side of the motorcycle.

9. Reinstall Seat:

  • Reinstall the OEM seat.