Road Glide LED Headlight Install from HOGWORKZ® (Fits '98-'13 Harley® Road Glide models)

Incredible savings and superb functionality with our HOGWORKZ® Dual LED Halomaker® Road Glide headlight. This unit will get you noticed. Increase visibility, safety, and style with a pure white road tested LED setup featuring HOGWORKZ®' renowned "Halo" LED DRL rings!

Buzz Free Anti-Interference Design There is no shortage of cheap LED solutions, but saving a penny might net you a buzzing headlight that cripples your bike's radio signal. HOGWORKZ® specifically designed their Dual LED Headlights to use anti-interference electronics and passive (no hum) cooling. Gain the full advantage of an LED Headlight without losing a radio signal.

360_20250311135321

1. Remove Headlight Assemblies from Base Plate:

  • For 2010-2013 models, begin by removing the two existing headlight assemblies from the base plate they are mounted to.
360_20250311142404_

2. Remove Front Bezel:

  • Carefully remove the front headlight bezel.
  • Locate the four retaining tabs: two on the bottom and two on the top.
  • Gently disengage the tabs to remove the bezel.
360_20250311142228_

3. Remove OEM Headlight Assemblies:

  • Remove the original equipment manufacturer (OEM) headlight assemblies.
  • Each assembly is secured by four screws around its perimeter.
  • Unplug the factory wiring harness connected to each OEM headlight.
360_20250311143126_

4. Connect HOGWORKZ Halo Maker Assembly:

  • Connect the HOGWORKZ Halo Maker headlight assembly to the factory wiring harness.
  • The halo DRL is pre-wired to function with both high and low beam settings.

5. Secure New Headlight Assemblies:

  • Secure each HOGWORKZ headlight assembly to the base plate using the four screws previously removed.

6. Reattach Headlight Bezel:

  • Reattach the headlight bezel.
360_20250311143252_